Filter
Top Products
18 GTO 4000XLS Instruction Manual © 01.10.12
DIP Switches
DIP Switch Settings (MODES)
DIP Switch #1: Soft Start/Stop
ON– Soft start enabled (factory
preset).
OFF– Soft start disabled.
The Soft Start/Stop feature slowly
starts the gate as it begins to open
and slows the gate as it comes
to the closed position. This saves
wear and tear on the gate and gate
operator system.
DIP Switch #2: Warning Buzzer
ON– Buzzer warning enabled
(factory preset).
OFF– Buzzer warning disabled.
The Warning Buzzer alerts
you when the gate operator is
beginning to either open or close
the gate. It sounds for the rst 2
seconds in each direction. It also
sounds a warning when the gate
obstructs two times in one cycle.
Switching this to OFF only disables
the open and close warning not
the obstruction warning.
DIP Switch #3: Push/Pull-To-Open
ON: Push-To-Open.
OFF: Pull-To-Open (factory preset).
If your gate opens into the
property the DIP Switch is set to
the OFF position (factory setting).
If your gate opens out from the
property the DIP Switch must be
set to the ON position. NOTE: if
you have a Push-to-Open gate
application you will need a Push-
To-Open bracket (see Push-To-
Open Instructions on page 21).
DIP Switch #4: Dual Operation
ON– Second opens simultaneously
with master.
OFF– Second opens after master
(factory preset).
Note: Not applicable for single gate
operator.
DIP Switch Settings
1 2 3 4
ON DIP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
2ND LIMIT
S3
S4
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
2ND OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
AUTO CLOSE TIME STALL FORCE
1 2 3 4
ON DIP
SOFT START OFF
WARNING OFF
OPEN PULL
2ND OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN
ON
OFF
1
ON DIP
2 3 4