Filter
Top Products
GTO 4000XLS Instruction Manual © 01.10.12 15
RED wire to POSITIVE (+) terminal
BLACK wire to NEGATIVE (–) terminal
RED
BLACK
Step 2
IMPORTANT: Connect the BLACK battery wire to the NEGATIVE (–)
batteryterminal.ConnecttheREDbatterywiretothePOSITIVE(+)
terminal. Reverse connection of battery wires will damage the
control board.
Step 3
Plug the transformer
into the electrical outlet. (Use of a surge protector with the
transformer is strongly recommended.) IMPORTANT: This is a
class II indoor transformer; if using transformer outdoors be sure
to enclose it in a weatherproof case.
Control Board Settings
Step 1
Power switch is on, gate
is in the OPEN position,
operator arm
fully retracted.
Step 2
Press the transmitter to
activate operator arm.
The gate will begin
to CLOSE.
Step 3
When the gate reaches
the desired CLOSED
position, press
the transmitter
to stop the gate.
Learn Master
Limit Button
1 2 3 4
ON DIP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
2ND LIMIT
S3
S4
S2
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
AUTO CLOSE TIME STALL FORCE
Step 4
With the gate at the
correct position,
program the closed
limit setting by
pressing and holding
LEARN MAST LIMIT.
Gate in
OPEN
Postion
Gate
Closing
Gate
Closed
Gate in
OPEN
Postion
Control
Box
Control
Box
Control
Box
ON/OFF Switch
ON/OFF
Control
Box
Step 5
Press the transmitter
again to allow the gate
to return to
the fully OPEN
position.
The gate closed position is now programmed.
If you make a mistake and set the limit at the
wrong position: press your transmitter to return
the gate to the fully opened position, then press
and hold the LEARN MAST LIMIT button for 5
seconds. This will clear the memory for the closed
limit position. Repeat Steps 1-5.
Set Closed Position Limit (for Pull-To-Open Applications)