Filter
Top Products
Setup/Startup
3A2090A Operation 9
Setup/Startup
1. Perform Grounding Procedure (page 8) if using
flammable materials.
2. Fill throat packing nut with Throat Seal Liquid (TSL)
to decrease packing wear.
3. Check engine oil level. Add SAE 10W-30 (summer)
or 5W-30 (winter). See engine manual.
4. Fill fuel tank.
5. Set pump valve OFF.
6. If removed, install strainer.
7. Turn prime valve down. Turn pressure control coun-
terclockwise to lowest pressure.
NOTE: Minimum hose size allowable for proper
sprayer operation is 3/8 in. x 20 ft (9.5mm x 6mm).
8. Place siphon tube set in grounded metal pail par-
tially filled with flushing fluid. Attach ground wire to
true earth ground. Do 1. - 5. of Startup to flush out
storage oil shipped in sprayer. Use water to flush
water-base paint and mineral spirits to flush oil-base
paint and storage oil.
9. Apply brake.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing
fluid and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before
cleaning, checking, or servicing the equipment.
ti3307a
ti3308a
ti3309a
ti6470a
ti3430a
ti6473a
ti3441a
PAINT
FLUSH
ti3310a
ti18550a