Filter
Top Products
Driving Instructions
3A2090A Operation 19
Drive Engagement
The wheel motor bypass valve allows the operator to
disengage the wheel tension and push the unit around.
Rotate one complete turn counter-clockwise to
disengage.
Straight Line Adjustment
The front wheel is set to center the unit and allow the
operator to form straight lines. Over time, the wheel may
become misaligned and will need to be readjusted. To
re-center the front wheel, perform the following steps:
1. Loosen two bolts on the wheel alignment plate.
2. If striper arcs to the right, turn adjuster screw
clockwise.
3. If striper arcs to the left, turn adjuster screw
counter-clockwise.
4. Test-drive the striper. Repeat steps 2 and 3 until
striper drives straight. Tighten two bolts on wheel
alignment plate to lock the new wheel setting.
Handle Bar Height Adjustment
1. Loosen handlebar height adjuster lock.
2. Raise or lower handlebars to desired height.
3. Tighten handlebar height adjuster lock.
+
ti18576a
ti18586a
ti18585a
ti18591a
ti18592a
ti18557a
ti18549a
ti18573a