Filter
Top Products
Setup/Startup
3A2090A Operation 11
14. Increase pressure control enough to start pump.
Allow fluid to circulate for 15 seconds.
15. Turn pressure down, turn prime valve horizontal.
Disengage gun trigger safety.
16. Hold gun against grounded metal flushing pail. Trig-
ger gun and increase fluid pressure slowly until
pump runs smoothly.
17. Inspect fittings for leaks. If leaks occur, turn sprayer
OFF immediately. Perform Pressure Relief Proce-
dure. Tighten leaky fittings. Repeat Startup, steps 1
- 7. If no leaks, continue to trigger gun until system
is thoroughly flushed. Proceed to step 9.
18. Place siphon tube in paint pail.
19. Trigger gun again into flushing fluid pail until paint
appears. Assemble tip and guard.
20. Repeat steps 6 - 10 on second gun for 2-gun mod-
els.
SwitchTip and Guard Assembly
1. Engage trigger safety. Use end of SwitchTip (A) to
press OneSeal (B) into tip guard (D), with curve
matching tip bore (C).
2. Insert SwitchTip in tip bore and firmly thread assem-
bly onto gun.
To avoid skin injection injury, do not stop leaks with
your hand or a rag.
15 SEC.
ti3442a
ti6472a
3304c
ti3441a
ti3442a
PAINT
ti3316a
ti3324a
ti6638a
A
B
C
D
ti3325a
ti3327a