Filter
Top Products
Smart Control Operation
28 3A2090A Operation
Angle Stalls
1. Angle stalls require the operator to input stall angle
and depth. The Auto-Layout System calculates the
offset distance based on this input.
2. From PARKING LAYOUT MODE press SETUP two
times for ANGLE CALC.
3. ANGLE: Press and hold Gun Trigger Control button
to change stall angle. Angle increases up to 90° and
wraps around and starts over at 45°.
STALL DEPTH: Press down arrow to decrease or
up arrow to increase stall depth.
STALL SIZE: Press down arrow to decrease or up
arrow to increase stall size.
4. Measure and mark the offset distance for the first
stall.
5. Press SETUP two times to save angled stall dot
spacing to PARKING LAYOUT MODE.
ti9919b
ti9921b
ti9919b
ti9921b