Filter
Top Products
Smart Control Operation
3A2090A Operation 27
Parking Layout Mode
NOTE: Please use the 286111 tip provided with striper
for parking lot layout work. For best performance set
pressure to 1000 psi (68.9 bar, 6.89 MPa) and reverse
tip.
Parking Mode
Basic Stalls
From MANUAL MODE press MODE button twice for
PARKING LAYOUT MODE. This display allows you to
change stall size and dot size. It also shows speed. The
two dots before and after PARKING MODE flash alter-
nately when Gun Trigger Control is pressed to signal
mode is active.
1. Press down arrow opposite DOT SIZE to decrease
dot size. Press up arrow to increase dot size.
2. Press down arrow opposite STALL SIZE to
decrease stall width. Press up arrow to increase
stall width.
3. Press Gun Trigger Control button and move striper
forward. Striper marks dots every 9.0 ft (or stall size
you have set) until Gun Trigger Control button is
pressed again.
Advanced: Parking Calc
1. Press SETUP and move to PARKING CALC. The
striper divides the stall size into the measurement
taken here to determine the number of stalls that
can be striped in this space.
2. The last length measured in the MEASURE MODE
is transmitted to this display, or press Gun Trigger
Control to start measuring (press Gun Trigger Con-
trol again to stop measuring). You can change
STALL SIZE (wider or narrower) or CALC #
STALLS (total number of stalls).
3. Press SETUP three times to return to PARKING
LAYOUT MODE. Press Gun Trigger Control button,
move forward and start to mark dots. Press Gun
Trigger Control button again to end dots.
MODE
ti9919b
ti9919b
ti18564a
ti18717a
ti9920b
ti9919b
ti9920b
ti9919b