Filter
Top Products
Smart Control Operation
3A2090A Operation 23
6. Press SETUP twice to move to CALIBRATION &
UNITS display. Set TRAVEL DISTANCE to 25 ft.
Longer distances ensure better accuracy, depend-
ing on conditions.
\
7. Align calibration bar rear edge with 1 foot on steel
tape.
8. Push gun trigger control to start calibration.
9. Move striper forward. Keep calibration bar over steel
tape.
10. Stop when calibration bar rear edge aligns with
26-ft. on steel tape (25-ft. distance).
11. Push gun trigger control to complete calibration.
12. NEW CALIBRATION STORED displays. Press
EXIT. Calibration is now complete.
13. Go to MEASURE mode and verify accuracy by
measuring the tape (see MEASURE MODE).
Calibration Error Displays
This message is displayed if striper has rolled beyond
calibration length when gun trigger control is pressed to
end calibration.
This message is displayed if striper has rolled less than
calibration length when gun trigger control is pressed to
end calibration.
ti9915b
ti9926b
ti10021a
1 FT
ti18564a
ti18717a
ti10022a
26 FT
ti18564a