• Fit a wheel, rib side in, onto the front axle.
• Slide a hubcap, peg side in, onto the front axle.
• Slide a
7
/
16
" washer onto a front axle.
• Slide a bushing, ring side first, onto a front axle.
• Fit a .437 cap nut on the end of the front axle.
• Fit the assembly tool over the cap nut. Tap the end of the
assembly tool with a hammer to secure the cap nut on the
end of the front axle. Pull the wheel to be sure it is secure.
13
15
14
Assembly
7
/
16
" Washer
Front Axle
Hubcap
(Peg Side In)
Wheel
(Rib Side In)
12
Front Axle
.437 Cap Nut
Assembly
Tool
Ring Side First
Bushing
Bottom View
Bushing
(Ring Side First)
Front Axle
.437"
• Turn the vehicle so that the front end is toward you.
• Lift the front end of the vehicle.
• Fit the steering linkage assembly to the front end of
the vehicle.
• Insert two #12 x 1
1
/
4
" screws into the holes in the steering
linkage. Tighten the screws.
• Pull the steering linkage to be sure it is secure. If it is not
secure, tighten the screws a few more turns.
12
Steering Linkage
Assembly
Bottom View