Filter
Top Products
• Position the vehicle upside-down.
• Slide the other rear wheel driver, ring side out, onto
the rear axle. Make sure the driver fits onto the pins in
the motor.
• Slide a wheel, rib side in, onto the rear axle. Make sure
the ribs on the wheel fit into the grooves on the rear
wheel driver.
• Slide a hubcap, peg side in, onto the rear axle.
6
• Fit a .437 cap nut on the end of the rear axle.
• Fit the assembly tool over the cap nut. Tap the end of the
assembly tool with a hammer to secure the cap nut on the
end of the rear axle. Pull the wheel to be sure it is secure.
Hint: You may need the help of another adult to support the
other end of the rear axle while you tap the cap nut.
7
• Slide the rear axle assembly through the hole in one
motor, the back end of the vehicle and then out through
the other motor.
5
Assembly
Rear Wheel Driver
(Ring Side Out)
Rear Axle
Wheel
(Rib Side In)
Motor
.437 Cap Nut
Assembly
Tool
Rear Axle
10
Rear Axle Assembly
.437"
Motor
Hole in Motor
Bottom View
Hubcap
(Peg Side In)
• Locate the motors inside the vehicle.
• Make sure each motor is positioned in the rectangular
recesses inside the vehicle.
4
Motors
Top View