D-Link DAP-2690 Breast Pump User Manual


 
26D-Link DAP-2690 User Manual
Section 3 - Conguration
Select Static IP (Manual) if you do not have a DHCP
server on your network, or if you wish to assign a static
IP address to the DAP-2690. When Dynamic IP (DHCP)
is selected, the other elds here will be grayed out.
Please allow about 2 minutes for the DHCP client to be
functional once this selection is made.
The default IP address is 192.168.0.50. Assign a static
IP address that is within the IP address range of your
network.
Enter the subnet mask. All devices in the network must
share the same subnet mask.
Enter the IP address of the gateway in your network. If
there is a router/gateway in your network, please enter
its IP address.
Enter a DNS server IP address of your choice. In most
cases, enter the LAN IP of your router.
LAN
Get IP From:
IP Address:
Subnet Mask:
Default
Gateway:
DNS:
LAN is short for Local Area Network. This is considered your internal network. These are the IP settings of the LAN interface for the DAP-2690. These
settings may be referred to as private settings. You may change the LAN IP address if needed. The LAN IP address is private to your internal network
and cannot be seen on the Internet. After completing the desired LAN settings, click the Save button to let your changes take eect.