Filter
Top Products
42
RP360 / RP360 XP
• Stomp Mode
This mode is used to turn individual effects on and off with the
footswitches and mimics using stompboxes� Using this mode, you
can assign any effect in a preset’s effects chain to one of the three
footswitches� This effect assignment is displayed in the LCD display in
REVERB
Plexi-Drive 1
MOD FX DELAY
the Performance state, where each 1/3rd section of the LCD display corresponds to
a footswitch (i�e�, left section=Footswitch 1, middle section=Footswitch 2, and right
section=Footswitch 3)� For information on assigning effects to the footswitches, see Assigning
Effects To Footswitches (Stomp Mode Only) on page 24�
When in Stomp Mode, pressing
FOOTSWITCH 2 and 3 simultaneously will access the Looper
and turn Footswitches 1 and 2 back into preset up/down navigation footswitches (the RP
will essential work the same as it does in Preset Mode)� Pressing
FOOTSWITCH 2 and 3
simultaneously again will get you back to the stompbox style functionality found in Stomp Mode�
The following table shows RP footswitch functionality when in Stomp Mode�
RP Footswitch Functions In Stomp Mode
STOMP FOOTSWITCH MODE
RP
FOOTSWITCH
Plexi-Drive 1
LOOPER READY
SINGLE
FOOTSWITCH FUNCTIONS
Toggles effect 1 on and
off�
Toggles effect 2 on and
off�
Toggles effect 3 on and
off�
COMBINATION
FOOTSWITCH FUNCTION 1
Press to bypass all effects in the preset�
Press and hold to access the Tuner�
COMBINATION
FOOTSWITCH FUNCTION 2
Toggle between Stomp Mode functionality
(stompbox on/off) and Preset Mode
functionality (preset navigation and Looper
control)�
NOTE: When the Delay effect is assigned to one of the footswitches for control in Stomp
Mode, pressing and holding the assigned footswitch will access the Tap Tempo feature� See Tap
Tempo on page 33 for more information on using Tap Tempo�