Filter
Top Products
37
RP360 / RP360 XP
Using An Optional FS3X Footswitch
An optional DigiTech FS3X Footswitch can be connected to the RP’s CONTROL IN connector to add
three additional footswitches for RP control� There are two parameters in the System Settings menu
that will determine how these FS3X footswitches will function, they are: the CONTROL IN parameter
and the FOOTSWITCH MODE parameter� These parameters are accessed by pressing the
SYSTEM
button� See Control In on page 49 for further information on changing the CONTROL IN option�
See Footswitch Modes on page 41 for further information on changing the RP’s FOOTSWITCH
MODE�
FS3X Footswitch Functions
The below matrix shows the functions each of the FS3X footswitches will perform depending upon
how you configure the CONTROL IN and FOOTSWITCH MODE parameters�
FOOTSWITCH MODE
SET TO “PRESET”
FOOTSWITCH MODE
SET TO “STOMP”
FOOTSWITCH MODE
SET TO “BANK”
DISPLAY
Plexi-Drive
1
LOOPER READY
REVERB
Plexi-Drive
1
MOD FX DELAY
Plexi-Drive
1
1 2 3
BANK: 1
FS3X
FOOTSWITCH
CONTROL IN
SET TO “FS3X”
Preset
Bypass
Tuner -
*Multi
Loop
Preset
Down
Preset
Up
*Multi
Loop
Bank
Down
Bank
Up
CONTROL IN
SET TO “LOOPER”
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi Loop means a single footswitch controls multiple Looper functions. See the diagrams on the following
pages to see each of these Looper functions.