Filter
Top Products
41
RP360 / RP360 XP
SYSTEM SETUP
The System Settings menu is used for configuring global RP settings and is accessed by pressing the
SYSTEM button� Once in the System Settings menu, pressing the SYSTEM button or SELECT knob
repeatedly navigates the various pages within the menu (current page selection is indicated in the
upper right-hand corner of the LCD display)� The on-screen parameters can be adjusted using the
three
EDIT knobs located below the LCD display� The parameters available in this System Settings
menu are global (system wide) parameters and are not stored to individual presets, but are retained in
the processor�
Footswitch Modes
Footswitch Modes allow you to determine how
the RP footswitches will function� There are three
Footswitch Modes to choose from, they are:
PRESET MODE, STOMP MODE, and BANK MODE�
The following sections describe each of these
modes in further detail�
Plexi-Drive 1
LOOPER READY
SYSTEM SETTINGS 1/4
FOOTSWITCH
MODE
OUTPUT
TO
OUTPUT
MODE
PRESET
STOMP
BANK
AMP
MIXER
MONO
STEREO
• Preset Mode
This is the default Footswitch Mode� This mode is used to navigate
through all presets and provides access to the Looper� The following
table shows RP footswitch functionality when in Preset Mode�
Plexi-Drive 1
LOOPER READY
RP Footswitch Functions In Preset Mode
PRESET FOOTSWITCH MODE
RP
FOOTSWITCH
Plexi-Drive 1
LOOPER READY
SINGLE
FOOTSWITCH FUNCTIONS
Preset
Down
Preset
Up
*Multi
Loop
COMBINATION
FOOTSWITCH FUNCTION 1
Press to bypass all effects in the preset�
Press and hold to access the Tuner�
*Multi Loop means a single footswitch controls multiple Looper functions (i.e., loop record, overdub, play,
stop, and clear).