Filter
Top Products
Rev J Doc 01-20098 Page 14 of 44
H. USING MANUAL CONTROLS
Figure 13. Manual Controls, Location and Operation.
If necessary, use the manual controls on Manual Input Terminal TB2 (OPEN, CLOSE,
and STOP, as shown in Figure 13), to move the gate for system installation.
• To open the gate: connect the OPEN and STOP terminals to the COMMON
terminal.
• To close the gate: connect the CLOSE and STOP terminals to the COMMON
terminal.
• To stop the gate: disconnect the STOP terminal from the COMMON terminal.
IMPORTANT NOTE
If the STOP terminal is disconnected from the Common terminal, the gate is
prevented from moving and no command will affect the gate.