Filter
Top Products
Reference
E-151
Notes keep sounding, without stopping. • Turn power off and then back on to initialize all Digital Keyboard settings (page
E-13).
• Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
Some notes are cut off while they are
playing.
Notes are cut off whenever the number of notes being sounded exceeds the
maximum polyphony value of 64 (21 to 32 for some tones). This does not indicate
malfunction.
The volume or tone setting I configured
has changed.
• Adjust the volume setting (page E-13).
• Turn power off and then back on to initialize all Digital Keyboard settings (page
E-13).
• Replace the batteries with new ones or switch over to AC adaptor power (page
E-9).
Output volume does not change even
though I change my keyboard pressure.
• Change the Touch Response setting (page E-131).
• Turn power off and then back on to initialize all Digital Keyboard settings (page
E-13).
In certain keyboard ranges, the volume
and tone quality sound are slightly
different from those in other keyboard
ranges.
This is due to system limitations. It does not indicate malfunction.
With some tones, octaves do not change
at the far ends of the keyboard.
This is due to system limitations. It does not indicate malfunction.
The pitch of the notes does not match
other accompanying instruments or
sounds strange when played along with
other instruments.
• When the B indicator is displayed, it means that the transpose setting
(page E-18) has been used to change the pitch of the keyboard. Return the
transpose setting to 00.
• When the C indicator is displayed, it means that the scale setting (page
E-21) has been used to change the Digital Keyboard’s initial default setting. Use
the procedure under “To select a preset scale” (page E-21) to change to the
“Equal” preset scale.
• Turn power off and then back on to initialize all Digital Keyboard settings (page
E-13).
The reverb of notes seems to change
suddenly.
• Check and adjust the reverb setting (page E-31).
• Turn power off and then back on to initialize all Digital Keyboard settings (page
E-13).
Operation
Tone, rhythm, and other settings revert to
their initial defaults whenever you turn on
the Digital Keyboard.
The Digital Keyboard may be configured to restore default settings (factory default
settings or settings registered by you) when power is turned on. If you want the
Digital Keyboard to remember its last setup and restore it the next time it is turned
on, select “on” for the Auto Resume setting (page E-134).
Computer Connection
I can’t exchange data between the Digital
Keyboard and a computer.
• Check to make sure that the USB cable is connected to the Digital Keyboard and
computer, and that the device is selected correctly with your computer’s music
software settings (page E-145).
• Turn off the Digital Keyboard and then exit the music software on your computer.
Next, turn the Digital Keyboard back on and then restart the music software on
your computer.
Symptom Action
CTK7200_e.book 151 ページ ２０１４年３月７日 金曜日 午後３時４分