Filter
Top Products
Recording and Playing Audio
E-127
4.
Press the L-16 (PLAY/STOP) button.
• This will start playback of the audio file and cause the
L-16 (PLAY/STOP) button to change from flashing to
lit. The time counter also will start counting up.
• The following operations are supported during
playback.
* Dial operation is supported only while the audio play screen
is displayed.
• Playback stops automatically when it reaches the end
of a song. To stop playback part way through, press the
L-16 (PLAY/STOP) button.
5.
To exit the audio play mode, press the C-6
(AUDIO PLAY) button.
• This returns to the mode screen (rhythm mode or song
sequencer mode) that was displayed before you
performed step 1 of this procedure.
• During audio record standby, you can exit the audio play
mode by pressing the R-15 (EXIT) button.
• During the above operation, you can press the C-6 (AUDIO
PLAY) button to exit the audio play mode.
■About center cancel
Center cancel can be used to cut out the vocal part (which is
normally located in the center of the stereo field) from an
audio file stored to a memory card from your computer. How
successful center cancel is in cutting out the audio depends
on the audio file you are playing back.
Each press of the L-17 (PART SELECT) button toggles
between center cancel and normal (no center cancel)
playback. The current setting can be determined by checking
the graphic formed inside the level indicator as shown below.
• When the MIC/INST parameter (page E-42) “Pan” setting is
“0” (initial default value), center cancel is applied to all
sound recorded from an external device connected to the
T-6 (MIC IN) jack or the T-4 (INST IN) jack.
To perform this
operation:
Do this:
Fast forward Hold down the L-14 (dFF) button or
rotate the dial to the right.
*
Fast backward Hold down the L-13 (sREW) button
or rotate the dial to the left.
*
Pause Press the L-15 (PAUSE) button.
Restart paused
playback
Press the L-15 (PAUSE) button.
Lower playback
volume
Press the R-14 (–) button, which will
display a volume setting screen.
Rotating the dial to the left while this
screen is displayed also will lower
playback volume.
Raise playback
volume
Press the R-14 (+) button, which will
display a volume setting screen.
Rotating the dial to the right while this
screen is displayed also will raise
playback volume.
Center cancel Press the L-17 (PART SELECT)
button.
Status Playback standby
Playback in
progress
Normal
Center cancel
CTK7200_e.book 127 ページ ２０１４年３月７日 金曜日 午後３時４分