Filter
Top Products
Recording and Playing Audio
E-124
4.
If required, perform the steps below to switch
from the time counter screen to the tempo,
measure, beat screen. If you want to leave the
time counter displayed, go straight to step 5.
5.
Use the dial or the R-14 (–, +) buttons to select
an audio file number.
6.
To start recording, press the C-2 (AUDIO
RECORD) button.
• If the file number you selected in step 5 does not have
an asterisk (*) next to it, the C-2 (AUDIO RECORD)
button will change from flashing to lit and recording will
start. Start to play what you want.
• If you selected a file number with an asterisk (*) in front
of it in step 5, a file overwrite confirmation screen like
the one shown below will appear.
If you do not want to overwrite the file, press the R-14
(NO) button. This will return to step 5 of this procedure
where you can select a different audio file number.
If you do want to overwrite the file, press the R-14 (YES)
button. Recording will start and the C-2 (AUDIO
RECORD) button will change from flashing to lit. Start to
play what you want.
7.
To quit recording, press the C-2 (AUDIO
RECORD) button again.
• This will cause the button to change from lit to unlit and
end recording.
• The > indicator will stop flashing on the display to
indicate the audio play mode.
• Pressing the L-16 (PLAY/STOP) button here will stop
recording and start playback of the audio file. For
details about audio file playback, see “Playing Back
Audio” (page E-126).
• To exit the audio play mode, press the C-6 (AUDIO
PLAY) button.
• During audio record standby, you can exit the audio record
mode by pressing the R-15 (EXIT) button.
• If you switch from the time counter to tempo, measure, beat
in step 4 of the procedure above, the count up operation will
begin when song (when in the song sequencer mode) or
rhythm (when in the rhythm mode) playback is started.
• The time counter (or tempo, measure, beat display) will
start to flash when there are 30 seconds of remaining
recording time. Recording will stop automatically when the
end of remaining recording time is reached.
(1) While holding down the R-13 (FUNCTION) button,
press the C-17 (MENU) button.
This displays a screen like the one shown below.
(2) Use the R-17 (y) button to move the thick brackets
(%) to “Measure Beat” and then press the R-15
(EXIT) button.
This switches from the time counter to the tempo,
measure, beat screen.
To return to the time counter screen, the R-17 (t)
button in step (2) to move the thick brackets (%) to
“Recording Time” and then press the R-15 (EXIT)
button.
Flashing (Record standby) Lit (Recording)
CTK7200_e.book 124 ページ ２０１４年３月７日 金曜日 午後３時４分