Filter
Top Products
Recording and Playing Audio
E-128
1.
Perform steps 1 through 4 under “To play back
a recorded audio file” (page E-126) to start
playback.
2.
When playback reaches the location you want
to specify as the repeat start point, press the
L-12 (REPEAT) button.
• This will display a screen like the one shown below,
which shows the start point you specified
(minutes:seconds) and the flashing ? indicator.
3.
When playback reaches the location you want
to specify as the repeat end point, press the
L-12 (REPEAT) button again.
• This will immediately return to the start point you
specified in step 2 and start repeat playback. At this
time a screen like the one shown below showing the
end point you specified (minutes:seconds) will be
displayed first. After a few seconds, the display will
change to the original audio play screen.
• The ? indicator will be on the display while repeat
playback is in progress.
• The operations you can perform during repeat playback
are the same as those that are supported during normal
playback. For details, see step 4 under “To play back a
recorded audio file” (page E-126).
4.
To cancel repeat playback, first press the L-16
(PLAY/STOP) button to stop it. Next, press the
L-12 (REPEAT) button.
• This causes the ? indicator to disappear from the
display.
1.
Press the C-6 (AUDIO PLAY) button to enter the
audio play mode.
2.
Use the dial or the R-14 (–, +) buttons to display
the audio file number of the file you want to
rename.
3.
While holding down the R-13 (FUNCTION)
button, press the C-17 (MENU) to display the
audio play menu.
4.
The 0 should be next to “Rename”, so press
the R-16 (ENTER) button.
• This displays the “Rename” screen.
5.
Use the R-17 (u, i) buttons to move the
cursor to the name character position you want
to change, and then use the dial or R-14 (–, +)
buttons to select the character you want.
• For details about the characters you can input, see
“Supported Input Characters” (page E-160).
• To input a space, press both of the R-14 (–, +) buttons
at the same time.
6.
Press the R-16 (ENTER) button.
7.
In response to the “Sure?” message that
appears, press the R-14 (YES) button to change
the name or the R-14 (NO) button to cancel and
return to the audio play screen.
• Pressing the R-15 (EXIT) button without pressing the
R-14 button will return to the screen in step 5 of this
procedure.
To repeat play a specific phrase To rename an audio file
CTK7200_e.book 128 ページ ２０１４年３月７日 金曜日 午後３時４分