Filter
Top Products
26 27
1 Rotate the positioning block to
the front and place the child
seat on the vehicle seat.
* Ensure harness height is
adjusted to fit your child.
2 Pull the vehicle belt out and
route the belt through the first
belt slot, under the cover and
through the second belt slot.
3 Verify that the belt is not
twisted and then buckle.
4 Push the child seat firmly
into the vehicle seat while
removing all slack from the lap
part (a), then shoulder part (b)
of the vehicle belt.
5 Manually feed the vehicle seat
belt into the retractor.
6 Ensure that the shoulder belt
rests behind the Side Impact
Cushion and against the
vehicle seat when installed.
* Ensure that the vehicle belt
is locked as directed by your
vehicle owner’s manual.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 1 in.
(2.5 cm) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
7 Firmly press the Versa-Tether
®
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
8 Use the elastic strap to contain
extra webbing.
OR
OR
Checklist
9 Check that positioning block is rotated to the front.
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Ensure any excess Versa-Tether
®
webbing is stored in elastic
band. Always ensure any excess webbing is contained within
your vehicle.
Before you begin:
9 Check that your vehicle has a seat belt that can be locked.
* Check your vehicle owner’s manual to determine what type
of vehicle belt you have and how it can be locked for use with
child seats. If your vehicle belt does not lock, a locking clip must
be used. Call Britax Consumer Services at 1(888)427-4829 to
obtain a locking clip.
9 Check that your vehicle has a top tether anchor?
* Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner’s manual for
tether anchor locations.
9 Remove the Versa-Tether
®
hook from the storage clip and
place it over the child seat back to keep it from becoming
pinned between the child seat and vehicle seat during
installation.
Lap-Shoulder Belt – Long Path
Versa-Tether
®
(Top Tether)
Long lap-shoulder belt path installation
Installing the Child Seat: Harness Mode Installing the Child Seat: Harness Mode