Filter
Top Products
18 19
Using the LATCH Connectors
The LATCH connectors are located on the sides of the shell in the
storage slots. Store the LATCH connectors when not in use.
To remove the LATCH connector from the storage slot or lower
anchor:
1 Press and hold the red release
button.
2 Pull the LATCH connector
from the storage slot or lower
anchor.
To attach the LATCH connector to the storage slot or lower
anchor:
Firmly push the LATCH connector
into the slot or lower anchor until a
click is heard to store.
NOTE: The LATCH connectors
store in the slots upside-down.
Top
Using the Versa-Tether
WARNING!
•Attach the Versa-Tether only to tether anchors identified by
your vehicle manufacturer as tether anchorage points.
•If your vehicle does not currently have a tether anchor
attachment, refer to your vehicle owner’s manual or
contact your vehicle man u fac tur er for assistance. DO
NOT modify your vehicle without advice from your vehicle
manufacturer.
When using the child seat in harness mode:
•Britax recommends that the tether be used at all times
when installing the child seat. Using the tether will improve
the stability of your child seat and reduce the risk of injury.
Tether anchor locations vary
from vehicle to vehicle. Check
your vehicle owner’s manual
and look for the tether anchor
symbol shown in the diagram
to help identify where the top
tether anchor point is located
in your vehicle.
OR
OR
To remove the Versa-Tether from the storage clip:
1 Remove the webbing from the
elastic strap and loosen the
Versa-Tether.
2 Remove the Versa-Tether
®
hook from the storage clip.
To attach the Versa-Tether to the storage clip or a tether
anchor:
1 Firmly press the hook over the
storage clip or tether anchor
point.
2 Always attach the hook over
the anchor point.
IMPORTANT: Use the elastic strap
to contain extra webbing. Always
ensure any excess webbing is
contained within your vehicle.
OR
OR
Child Seat FunctionsChild Seat Functions