Wired/On-Air Programming
49
• Channel number (from 1 to
200)
• Frequency (any frequency the
scanner can receive)
• Car number (from 0 to 999,
including 00, 000, 01, and
001)
• Channel lockout setting (ON
or OFF)
• Channel delay setting (ON or
OFF)
Ô
USING WIRED
P
ROGRAMMING
1. Turn off the scanner.
2. Connect the scanner to the
PC using a PC cable.
3. While pressing ENT and 9,
turn on the scanner.
PGM and
WirEd appear. Then send
the data from the PC.
StArt
and the data being received
by the scanner appears in the
order it is received.
Ô
4. When the scanner
successfully receives all data,
End and FiniSh appear. If
the scanner received an error
while receiving data,
End
and d-Err appear. If the
scanner received a checksum
error while receiving data,
C-
Err and a number appear.
The number shown next to
C-Err indicates the packet
number where the error
occurred.
Ô NOTE Ô
• The scanner
receives only the
data shown above
during wired/on-air
programming.
•
d-Err (data
error) appears if
the scanner
receives a channel
number equal to 0
or frequency data
which is out of the
range of
frequencies the
scanner can
receive.
Using Wired
Programming
•Wired
programming
stops if the
scanner receives
an empty channel
number.
• If the scanner
receives no data
from the PC for
more than 20
seconds or if you
press any key,
wired
programming
stops.
• If the scanner did
not receive a start
bit from the PC,
StArt does not
appear.
• If the scanner did
not receive an end
bit from the PC,
End does not
appear.
