Operation
27
that band for an active
frequency.
3. If necessary, select a search
group from the list with
“Service Banks” on Page 19
then use the number keys to
enter the desired search
group. The scanner searches
for an active frequency.
Ô
4. When the scanner finds an
active frequency, it stops
searching and displays the
frequency’s number. To store
the displayed frequency in the
lowest available channel,
press PGM then ENT.The
channel and frequency flash
twice, and the scanner stores
the displayed frequency. The
scanner then continues to
search for frequencies.
Or, to store the displayed
frequency in a channel you
select, press PGM,usethe
number keys to enter the
channel number you want to
use to store the frequency,
then press PGM again. The
channel number flashes.
If a channel number you
entered is already
programmed with a
frequency, the channel
number and the programmed
frequency appear for about 2
seconds. Then the channel
number flashes and the new
frequency appears.
Press ENT to program the
new frequency or press CL/
MON to cancel. If you press
Ô NOTE Ô
•Youcanusethe
scanner’s delay
feature while
searching the
service banks.
See “Delay” on
Page 41.
• Tolistentothe
MRN bank, see
“Listening to the
Marine Bank” on
Page 33.
•
-b- does not
appear if the CAR
bank is selected.
• To reverse the
search direction at
any time, hold
down ▲ or ▼ for
about 1 second.
• To search up or
down the band in
small increments,
repeatedly press
▲ or ▼. ▲ or ▼
disappears. (See
“Service Banks”
on Page 19 for
frequency steps).
• To pause the
search while
receiving a signal,
press ▲ or ▼. ▲ or
▼ disappears. To
resume searching,
hold down ▲ or ▼.
• To quickly move
up or down
through the
frequencies, hold
down ▲ or ▼.The
scanner tunes
through the
frequencies until
you release ▲ or
▼.
