Wired/On-Air Programming
48
reset button inside the
opening.
Ô
Initializing the Scanner
1. Turn off the scanner, then turn
it on again.
!
2. Hold down MON/CL.
3. While holding down MON/CL,
insert a pointed object (such
as a straightened paper clip)
into the reset opening on the
side of the scanner, then
gently press the reset button
inside the opening. The
display should turn off.
4. When the display turns on
again, release MON/CL.
Ô
WIRED/ON-AIR
PROGRAMMING
You can program your scanner
using data you transfer from your
personal computer to the scanner
using an optional PC cable (called
wired programming). You can also
program your scanner by receiving
data transmitted on a frequency
your scanner can receive (called
on-air programming).
You can use wired or on-air
programming to store the following
data into the scanner:
!
IMPORTANT
!
This procedure clears al
information youstored in
the scanner’s memory.
Initialize the scanner
only when you are sure
the scanner is not
working properly.
Ô NOTE Ô
Resetting the
Scanner
If the scanner still does
not work properly, you
might need to initialize
the scanner (see
“Initializing the
Scanner”).
Initializing the
Scanner
You must release the
reset button before
releasing
MON/CL;
otherwise the memory
might not clear.
