Special Features
47
3. When
oFF tonE or on
tonE
appear, release 2 and
ENT.
USING THE KEY LOCK
Once you program your scanner,
you can protect it from accidental
program changes by turning on
the keylock feature. When the
keypad is locked, the only controls
that operate are SCAN, MAN,
LIGHT, PGM, VOLUME, and
SQUELCH.
Ô
To turn on the keylock, hold down
until the scanner beeps
three times and appears. To
turn it off, hold down until
the scanner beeps three times and
disappears.
RESETTING/INITIALIZING
THE SCANNER
If the scanner’s display locks up or
does not work properly after you
connect a power source, you
might need to reset or initialize the
scanner.
!
Resetting the Scanner
1. Turn off the scanner, then turn
it on again.
2. Insert a pointed object such
as a straightened paper clip
into the reset opening on the
side of the scanner (as
shown), then gently press the
Ô NOTE Ô
The keylock does not
prevent the scanner from
scanning channels or
monitoring a single
channel, whichever
feature you last selected.
!
IMPORTANT
!
If you have problems,
first try to reset the
scanner (see “Resetting
the Scanner” on
Page 47). If that does
not work, you can
initialize the scanner
(see “Initializing the
Scanner” on Page 48);
however, this clears all
information stored in
your scanner’s memory.
