PERIODIC MAINT EN ANCE 2-45
Periodic Maintenan ce Procedures
•
Unscrew the thermostat bracket bolt [A].
○
If removing the spark plug #2 or #3.
•
Disconnect:
Stick Coil Connectors [A]
•
Pull out the stick coil #1 [B].
•
Take out the camshaft position sensor connector [ C] from
the bracket.
•
Pull out the stick coil #2 [D].
CAUTION
Do not pry the connector part of the coil while re-
moving the coil.
•
Remove the stick coil subharness connector [A] from the
bracket.
•
Remove:
Stick Coil Connector #4 [B] (disconnect)
Stick Coil #4 [C]
Stick Coil Connector #3 [D] (disconnect)
•
Disconnect:
Water Temperature Sensor Connector [A]
Left Switch Housing Connector [ B]
•
Pull the main harness [C] upward and remove the stick
coil #3 [D].
•
Remove the spark plugs using the 16 mm plug wrench
[A].
Owner’s Tool - Spark Plug Wrench, 16 mm: 92110–1132
