ENGINE LUB RICAT ION SYSTEM 7-15
Oil Pressure Measurement
Oil Pressure Measurement
•
Remove the oil passage plug, and attach the adapter [A]
and gauge [B] to the plug hole.
Special Tools - Oil Pressure Gauge, 10 kgf/cm²: 57001–164
Oil Pressure Gauge Adapter, PT 3/8:
57001
–1233
•
Start the engine and warm up the engine.
•
Run the engine at the specified s peed, and read the oil
pressure gauge.
If the oil pressure is much lower than the standard, check
the oil pump, relief valve, and/or crankshaft bearing insert
wear immediately.
If the r eading is much higher than the standard, check the
oil passages for clogging.
Oil Pressure
Standard: 255 ∼ 314 kPa (2.6 ∼ 3.2 kgf/cm², 37 ∼ 46 psi)
@4 000 r/min (rpm), oil temp. 90°C (194 °F)
•
Stop the engine.
•
Remove the oil pressure gauge and adapter.
WARNING
Take care against burns form hot engine oil that
will drain through the oil passage when the gauge
adapter is removed.
•
Apply a non-permanent locking agent to the oil passage
plug, and install it.
Torque - Oil Passage Plug (Right): 20 N·m (2.0 kgf·m, 14.5
ft·lb)
