A SERVICE OF

logo

FRAME 15-17
Side Stand
Side Stand Remov al
Raise the rear wheel off the ground with the stand.
Remove:
Muffler (both side)
Exhaust pipe
Side Stand Switch Bolt [A]
Side Stand Sw itch [B]
Spring [C]
Side Stand Nut [D]
Side Stand Bolt [E]
Side Stand [F]
Side Stand Installation
Apply grease to the sliding area [B] of the side stand [A].
Tighten the bolt and lock them with the nut.
Torque - Side Stand Bolt: 44 N·m (4.5 kgf·m, 32 ft·lb)
Hook the spring
Install the side stand switch.
Apply a non-permanent locking agent to the thread of the
switch bolt.
Torque - Side Stand Switch Bolt: 8.8 N·m (0.9 kgf·m, 78
in·lb)