A SERVICE OF

logo

FINAL DRIVE 11-9
Drive Chain
Turn wrench clockwise until tip of r iveting pin hits of link
pin.
Rivet it.
Some work for the other link pin.
After staking, check the staked area of the link pin for
cracks.
Measure the outside diameter [A] of t he link pin and link
plates outside width [B].
Link Pin Outside Diameter
Standard: 5.6 6.0 mm (0.22 0.24 in.)
Link Plates Outside Width
Standard: 19.85 20.00 mm (0.781 0.787 in.)
If the reading exceeds the specified length, cut and rejoin
the chain again.
Check:
Movement of the rollers
Adjust the drive chain slack after installing the chain (see
Drive Chain Slack A djustment in the Periodic Mainte-
nance chapter).