CRANKSHAFT/TR ANSMISSION 9-23
Transmission
•
Install the footpeg bracket [A].
•
Apply a non-permanent locking agent to the footpeg
bracket bolts [B].
•
Tighten:
Torque - Footpeg bracket Bolts: 34 N·m (3.5 kgf·m, 25 ft·lb)
Muffl
er Mounting Bolt and Nut [C]: 29 N·m (3.0
kgf·m, 22 ft·lb)
•
Install the shift lever [A], aligning the mark (previously
marked).
•
TIghten:
Torque - Shift Lever Bolt: 6.9 N·m (0.7 kgf·m, 61 in·lb)
•
Install the shift pedal [B] as shown.
[C] Right Angle (90°)
○
To adjust the pedal position, loosen the front locknut [D]
(left-hand threads) and rear locknut [E] and then turn the
tie-rod [F].
○
Tighten:
Torque - Tie-rod Locknuts: 6.9 N·m (0.7 kgf·m, 61 in·lb)
External Shift M echanism Removal
•
Remove:
Engine Oil (drain, see Engine Lubrication System chap-
ter)
Shift Pedal (see Shift Pedal Removal)
Clutch (see Clutch chapter)
Oil Pipe Holder Bolts [A]
Oil Pipe Holders [B], Oil P ipe [C] and O-ring
•
Remove the shift shaft assembly [A] while pulling the shift
mechanism arm [B] to the direction of the arrow.
