Filter
Top Products
Embedded Intel® Atom Processor D2700 with Intel® NM10 Express Chipset
26
25 MHz to 112 MHz singlechannel; @18 or 24 bpp
TFT panel type
Panel fitting, panning, and center mode
CPIS 1.5 compliant
Spread spectrum clocking
Panel power sequencing
Integrated PWM interface for LCD backlight inverter control
Flat panel brightness control via front panel button input as well as Windows* 7
brightness adjustment slider
NOTE
Support for flat panel display configuration complies with the following:
1. Internal flat panel display settings are not exposed through Intel
®
Integrator
Toolkit or Intel
®
Integrator Assistant GUIs.
2. Internal flat panel display settings will not be overwritten by loading BIOS setup
defaults.
3. Internal flat panel display settings will be preserved across BIOS updates.
2.7.5 Configuration Modes
For monitors attached to the VGA port, video modes supported by this board are based
on the Extended Display Identification Data (EDID) protocol.
Video mode configuration for LVDS displays is supported as follows:
Automatic panel identification via Extended Display Identification Data (EDID) for
panels with onboard EDID support
Panel selection from common predefined panel types (without onboard EDID)
Custom EDID payload installation for ultimate parameter flexibility, allowing
custom definition of EDID data on panels without onboard EDID
In addition, BIOS setup provides the following configuration parameters for internal
flat panel displays:
Screen Brightness: allows the end user to set the screen brightness for the display
effective through the Power-On Self Test stage (such as while showing the splash
screen image and BIOS setup). Windows 7 ignores this setting in favor of the
Brightness Steps: allows the system integrator to configure the brightness steps for
adjustment slider under the Windows
Flat Panel Configuration Changes Lock: allows the
critical settings of the LVDS configuration to avoid end users potentially rendering
the display unusable.
Color Depth: allows the system integrator to select whether the panel is 24 bpp or
18 bpp.
Inverter Frequency and Polarity: allows the system integrator to set the operating
frequency and polarity of the panel inverter board.