Filter
Top Products
Embedded Intel® Atom Processor D2700 with Intel® NM10 Express Chipset
107
5. Write the image to the USB stick by selecting Write.
6. Insert the USB stick into the CRB.
7. When you boot the BIOS be sure to select the USB stick as the primary boot drive.
8. When the selection options appear, select the second option to Installation Only
option.
9. Follow the prompts to install.
Note: MeeGo Bug number 23757 has been created recently due to a mismatch size of
the GUI installer when BOTH the VGA and LVDS screens are attached. If you do not
see the arrows or next buttons on the screen, you may press enter as the next buttons
will be enabled by default. Or you can attach just one monitor for the installation
procedure, and the GUI installer should size correctly.
7.5.4 Graphics Driver
The MeeGo Graphics driver is integrated into the MeeGo Alpha image. Since the
graphics capabilities are integrated in the image, no additional installations are
required, and no additional configuring is required to benefit from the Linux based
hardware accelerated graphics drivers. The source file for the stand alone files for the
graphics drivers in MeeGo are at:
http://download.meego.com/live/MeeGo:/1.2.0:/CedarTrail:/
7.5.5 Flash
Hardware accelerated flash for MeeGo can be downloaded from the following site:
https://registrationcenter.intel.com/RegCenter/ComForm.aspx?ProductID=1618.
7.6 Using Yocto Project*
This section provides step-by-step instructions for downloading the drivers for
platforms featuring the Intel® NM10 chipset and the Embedded Graphics Driver for the
Project*.
The step-by-step instructions in this section have been used with the Intel Customer
Reference Board (CRB). The information in this quick start guide is applicable to any