Filter
Top Products
Page 8SKU 95852
For technical questions, please call 1-800-444-3353
Tilt Latch
The Tilt Latch (47) allows the Cradle (41) to tilt to adjust
the panel as needed for installation on sloped ceilings
or walls.
To lock the Cradle in a level position, rotate the Latch
up to engage the stud in the Cradle.
NOTE: When in the locked position, the cradle will tilt
up to 10° side-to-side.
Brake Arm
The spring-loaded Brake Arm (30) will automatically
hold the Cradle at any height you raise it.
To lower the Cradle, grasp the Winch Wheel (27) to
prevent it rotating in an uncontrolled manner.
Raise the Brake Arm to release the Cradle, and lower
it carefully with the Winch Wheel.
Winch Wheel, Handle and Post
The Winch Wheel (27) is used to raise and lower the
Cradle, which holds the panel. This is done by means of
a Cable (24) which wraps around a spool in the Winch
Wheel Assembly.
If necessary, you can grasp the top of the Winch Post
(21) for leverage when raising a panel.
CAUTION: Pay attention to the action of the Cable when
operating this tool. Do not allow your hands, clothing,
hair or jewelry to come near the Cable. If these become
caught in the cable, you can be injured. Do not allow the
cable to become tangled or jammed during operation.
Retaining Hook
Catch the Retaining Hook (26) on the end of the Frame
housing (11) to prevent the telescoping portions of the
tool from shifting during storage or transport.
1.
2.
3.
1.
2.
3.
1.
2.
3.
1.