Filter
Top Products
Page 5SKU 95852
For technical questions, please call 1-800-444-3353
ASSEMBLY
Setting up the Tripod Base
Place the Tripod Base Assembly (1) on the floor
with the Casters (4) down.
Press down on the Slide Yoke Ring (5) while swing-
ing the two Outer Legs (3) out and back into place.
The Yoke Ring will snap into the hole in the bottom
of the Center Leg (2).
To keep the Tripod in position during assembly, rotate
the Backstop (7) down to lock onto the floor.
The Frame Assembly with Winch and Lift
Set the Frame Assembly (10) into the Tripod Base (1),
fitting the end into the V-shaped opening. Insert the
Frame Assembly about 1 inch to seat it in the base.
Be sure the Frame Assembly is firmly seated before
continuing.
Attach the Handle (34) to the Winch Wheel (27). Leave the
Nut loose enough for the Handle to rotate when in use.
Move the Winch Assembly (20) into its working position.
a. Rotate the Winch Wheel (27) forward slightly while lift-
ing the Brake Arm (30) to release the Brake.
b. Raise the Brake Arm all the way up with your left hand
and hold in place by gripping the Winch Post
c. Place your right hand on top of the Frame. Continuing
to hold the Brake Arm, pull the Winch Assembly toward
you as far as it will go.
d. Release the Brake Arm and move the Retaining Hook
(26) away to release the telescoping sections inside the
Frame Housing (11).
Push the Winch Assembly slightly back toward the
Frame to engage the Slide Bar Lock (23). Be sure that
Slide Bar Lock is engaged before continuing.
1.
2.
3.
1.
2.
3.
4.
1.
Please note: It is recommended that two or
more able workers assemble this product.