Filter
Top Products
Page 11SKU 95852
For technical questions, please call 1-800-444-3353
DISASSEMBLY
Remove any panel which might be on the Lift. Release
the Brake Arm (30) and crank the Winch Handle (34)
to lower the Cradle (41) all the way down.
Slide the Cradle Outriggers (44) all the way in until they
latch. Fold up the Panel Support Hooks (62).
Press the Spring Tab on the underside, and remove the
crossarms by sliding them out of the tapered socket.
Unlock the Cradle Latch (47). Raise the Cradle to re-
move it from the Frame.
Rotate the Winch Wheel one full revolution forward to
raise the inner telescoping section.
Unlock the Winch Assembly by lifting the Slide Bar (22)
with one hand, and rotating the Slide Bar Lock coun-
terclockwise with your other hand.
Hold the Slide Bar Lock (23) in this disengaged posi-
tion, and press down on the telescoping sections of the
frame with your other hand. The Winch Assembly (20)
will rotate toward the Frame Housing (11).
Crank the telescoping sections all the way down. Swing
up the Retaining Hook (26) and crank the telescoping
sections back up until they are secured by the hook.
Hold the Retaining Hook in position while rotating the
Winch Forward. The Winch Assembly will fold up against
the Frame. When the Slide Bar contacts the Frame, tighten the
cable by turning the wheel further to hold the Winch Assembly in
this position.
Lift the Frame and Winch Assembly to remove it from the Base.
To fold the Base, press down on the Slide Yoke Ring (5) and pivot
the Outer Legs (3) forward until they lock into place in closed
position.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.