Filter
Top Products
45
Installation Check list
The installation of this operator conforms to CLASS __________.
The installer verifies that (each item except safety edges must be checked):
____ Recommended safety edges were installed.
____ Customer was informed that this gate is for vehicular use ONLY. Pedestrians MAY NOT use this gate.
____ A separate gate or entrance was installed for pedestrian use.
____ Closed position stop plate was securely fastened.
____ All power cables, receiver cables, and transformer plugs were securely fastened.
____ Petroleum jelly was applied to the control board terminals.
____ All warning signs and labels were installed as specified in the IMPORTANT SAFETY INSTRUCTIONS.
____ The IMPORTANT SAFETY INSTRUCTIONS were reviewed with the customer.
____ The Installation Manual was given to the customer.
____ The customer was instructed to use silicone spray on the push/pull tube, front mount, and rear mount to maintain the
gate operator.
____ Customer was instructed about disconnecting the operator for manual operation of the gate
____ Customer was instructed about proper use of transmitter and (or) other entry controls.
____ Customer was asked to fill out customer support card and mail it to GTO, Inc.
____ Customer was asked to retain all receipts (receipts provide proof of warranty).
____ The completed installation was photographed from both the front and back of the gate. Photo was dated.
Installer’s Signature
Date
Customer’s Signature Date