Filter
Top Products
10
Control Box and Electrical Components
Single Gate Operator Parts List
OTHER MATERIALS YOU MAY NEED BEFORE YOU START THE INSTALLATION:
Depending on the type of gate and fence post, you may need some additional materials/hardware.
Some of these items can be found in the GTO/PRO Accessory Catalog.
• All gates will need a stop post in the open position. This post is not provided. See page 16,
Installation of Open and Closed Position Stops for more information.
• Low voltage wire may be needed. Length depends upon the distance between the transformer
power supply and the control box. See page 19, Powering the System and the Accessory Catalog
for wire and solar charging panels.
• If the gate is more than 1000' away from an AC power source you will need to use at least one GTO
Solar Panel to trickle charge the battery. See the Accessory Catalog.
• The diameter of the fence post should be at least 8" (round) or 6" (square) in order to mount the
post bracket (see page 12). An optional 4” bracket can be used with 4” post, and mounting bracket
adapters must be used with 4" and 6" round posts. (See Accessory Catalog).
• Depending upon the diameter of the fence post, you may need longer carriage bolts than those
provided. Bolts should be at least 1" longer than the diameter of the fence post (see page 12).
• If using thin wall tube or panel gates, see page 14 for recommended reinforcement materials.
•A horizontal or vertical cross member or mounting plate may be needed to mount the operator to
the gate. See page 11.
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
RB3270