Filter
Top Products
43
ACCESS-ories
GTO Low Voltage Wire
(RB509)
The 16 gauge dual conductor, multi-
stranded, direct burial low voltage
wire is required to connect the
control board to the solar panel or
the AC transformer. This wire is
also required for installation of
some
accessories such as keypads, locks,
or push buttons (available in 1000'
rolls and specially cut lengths).
Column Mount Lock Receiver
(433IH)
For mounting the Automatic Gate
Lock or Bulldog Pedestrian Lock
in areas with limited space
between the gate and post, such as
brick columns or walls.
Splice Kit - Direct Burial (RB708)
When direct burial wire running below
ground needs to be spliced the RB708
splice kit must be used.
Splice Kit - Above Ground (RB707)
For providing secure and moisture
resistant above ground splices for solar
panels, key pads, push buttons and
other accessories using GTO low
voltage wire.
Master
®
Pin Lock (RB975)
for GTO/PRO 1000/1200
Master
®
Pin Lock (FM320)
for GTO/PRO 2000/2200
The p
in lock is a substitute for the
clevis pin at either or both
mounting points of the GTO/PRO
1000 operator arms and the gate
bracket end of the GTO/PRO
2000. They help prevent theft of
the operator arm while allowing
quick release of the operator when
necessary.
Operator Solar Panel (FM123 ) - Improved, Amorphous Silicon (comes woth a Two Year Warranty)
This 10 watt solar panel is a battery charger for use with GTO/PRO Low Voltage Automatic Gate
Operator systems. Particularly suited for remote installations, the solar panel comes with tubular steel
support, mounting clips, wire connectors, and 8 ft. of low voltage wire (for longer lengths, see RB509). All
GTO low voltage operators are pre-wired for solar panels. Installation in some regions of the world will
require multiple panels for adequate charging power. Recommended for GTO/PRO 2000/2200, GTO/PRO
SL-1000/SL-1200.
Operator Solar Panel (FM122 ) - Improved Amorphous Silicon (comes woth a Two Year Warranty)
The 5 watt solar panel is a battery charger for use with GTO/PRO Low Voltage Automatic Gate Operator
systems. Particularly suited for remote installations, the solar panel comes with tubular steel support,
mounting clips, wire connectors, and 8 ft. of low voltage wire (see Low Voltage Wire for longer wire). All
GTO low volatge operators are pre-wired for solar panels. Installation in some regions of the world will
require multiple panels for adequate charging power. Recommended for GTO/PRO 1000, GTO/PRO 1200
and the GTO Bulldog Gate Lock.
Dual gate installations require minimum of two (2) 5 watt solar panels for adequate charging power.
4" (O.D.) Post Bracket (RB464)
Recommended for mounting GTO/PRO 2000
to a 4" gate post.
4" (O.D.) Round Post Bracket
Adapters (RB469)
These adapters are necessary when mounting
the 4" post bracket to a 4" (O.D.) gate post.
Two required for each gate. Use with 4"
Post Bracket (RB464).