Filter
Top Products
Assembly
F
12
• Turn the vehicle body upright.
• Gently bend the tab on one of the sidepipes under the
vehicle body.
• Insert a #8 x
3
/
4" screw through the hole in the vehicle
body floor and into the tab.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure on the other side of the
vehicle body.
Tab
Back of Vehicle
2
3
Battery
Clamp
Unit
Dash
• Position the dash upside down.
• Fit the battery clamp unit into the underside of the
dash so that the clamp fits into the grooves in the dash.
Make sure the battery clamp unit is flush against the
surface of the dash.
4
Battery
Clamp Unit
• Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
5
Battery
Compartment
Dash
• Position the dash on the vehicle body.
• Make sure the motor harness connector wires and
microphone cord are through the grooves in the dash.
• Insert a #10 x
1
/2" screw through each of the two corner
dash tabs nearest to the passenger compartment .
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment .
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip .
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
11
2
11
2
11
1
Battery Clamp Clip
11
1
11
1
11
2
11
2
11
2
Clamp
Grooves
11
2
11
1
Microphone Cord
Motor
Harness
Connector
Wires