Fisher-Price 78478 Baby Toy User Manual


 
Locate the battery compartment on the lights and
siren unit.
Loosen the screw in the battery compartment door with
a Phillips screwdriver. The screw will remain in the door.
Lift the battery compartment door to open it.
Insert four “AA” (LR6) alkaline batteries as indicated on
the battery compartment door.
Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
Battery Tips
Do not mix old and new batteries.
Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Battery leakage and corrosion can cause damage.
Dispose of batteries safely.
Never short circuit the battery terminals.
Non-rechargeable batteries are not to be recharged.
Only batteries of the same or equivalent type as
recommended in the “Battery Installation” instructions are
to be used.
If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
Rechargeable batteries are to be removed from the
product before they are charged.
If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
+
-
1.5V x 4
“AA” (LR6)
Shown Actual Size
Battery
Compartment
Door
Lights and Siren Unit
22
Lights and Siren Unit
Speaker
Front of Hood
Lights
and Siren
Unit Cord
23
Insert the lights and siren unit cord through the hole in the
center of the hood.
Fit the lights and siren unit to the top of the hood. Make
sure the speaker faces the front of the hood.
Insert two #6 x
7
/
16
" screws with washers through the
holes in the underside of the hood and into the lights and
siren unit. (The #6 x
7
/
16
" screws and #6 washers can be
found in the small parts bag enclosed with the lights and
siren unit and microphone.)
Assembly
17