Filter
Top Products
Hood
Tabs
Slot
Slot
• Position the hood over the front of the vehicle body.
• Insert the tabs on the hood into the slots in the
vehicle body.
Lights
and Siren
Unit Cord
Microphone
Cord
• Align the arrow on the lights and siren unit cord
connector with the arrow on the microphone cord
connector.
• Push to connect the lights and siren unit cord to the
microphone cord.
24
25
Lights and
Siren Unit Cord
Cord Retainer
Microphone
Cord
Battery
Compartment
26
• Remove the backing from the cord retainer.
Discard the backing.
• Apply the cord retainer to the back of the dash.
• Fit the lights and siren unit cord into the cord retainer clip.
• Close the hood.
Assembly
18
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the belt
catches against the slot. You will pull one T-loop through
the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
Short Seat
Belt Strap
Fastener
End
Seat
End
T-Loops
Slot
T-Loop (pull through slot)
27