Filter
Top Products
15
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tab
Slot
14
Brush Guard
Bumper
• Fit and hold the brush guard against the front bumper.
• Insert two #10 x 1" screws through the front of the brush
guard and into the bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Fit a spacer tube between the grille and the
back of the brush guard, as shown.
• Insert a #8 x 4" screw through the brush
guard and spacer tube and into the hole in
the grille.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to assemble the other
spacer tube on the other side of the grille.
Spacer Tube
16
Assembly
15
• Insert a hood latch into one of the holes in the vehicle
body, near the hood area.
• Twist the base of the hood latch
1
/
4
turn to secure it in the
vehicle body.
• Repeat this procedure on the other side of the hood area
to attach the other hood latch to the vehicle body.
Hood Latch
Hole
17
Hood
Latch