Fisher-Price 78478 Baby Toy User Manual


 
Battery Charging
Pb
Plug the charger connector into the battery .
Plug the charger into a standard 120 volt wall outlet .
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your vehicle. Please see the Battery
Installation section on page 24 for detailed instructions on
installing your battery. If your battery is already installed in
your vehicle, simply re-connect the motor harness
connector to the battery and lower and fasten the hood.
11
2
11
1
Battery
Charger
Connector
11
11
1
11
2
Assembly
F
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
WARNING
Turn the vehicle body upside down.
Fit the left sidepipe under the left (driver) side of the
vehicle body.
Insert two #8 x
3
/4" screws through the top of the left
sidepipe and into the screw pegs on the underside of
the vehicle body.
Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Repeat this procedure to assemble the right sidepipe to
the right side of the vehicle body.
Left Sidepipe
Screw Pegs
Vehicle
Body
Back of Vehicle
1