Filter
Top Products
4 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide
halt command, 2-14, 3-21
Halted message, 3-21
height of filer, 2-3
help tools
AutoTech service, 4-3
Internet, 4-2
TechConnect BBS, 4-3
TechFax service, 4-3
humidity, environmental requirements,
2-2
informational messages
see error and informational messages
installation brackets, 1-2
installing the filer, 2-1, 2-8
connecting to a disk storage shelf, 2-11
connecting to a power source, 2-20
connecting to a tape backup device,
2-14
connecting to the network, 2-15
establishing a terminal connection,
2-18
in a rack, 2-4
preparing for the installation, 2-1
Internet help tools, 4-2
Invalid PCI card slot n message, 3-14
ISA IOCHK message, 3-21
2
L2 parity error message, 3-11
LCD
see Liquid Crystal Display
LEDs
see Light Emitting Diodes
Light Emitting Diodes (LEDs), 1-2, 3-2
10/100Base-T Ethernet cards, 3-5, 3-6
activity LED on the front panel, 3-3
built-in Ethernet interface, 3-5
front panel, 3-2, 3-3
power LED on the front panel, 3-3
power supply, 3-3
quad-port 10/100Base-T Ethernet card,
3-6
status LED on the front panel, 3-3
Liquid Crystal Display (LCD), 1-3
Liquid Crystal Display (LCD) messages,
3-9
Data disk n x% rebuilt, 3-17
Disk hung during swap!, 3-21
Disk labels scramble!, 3-13
Disk n is broken, 3-17
Fault on shelf n, 3-18
Maintenance mode, 3-18
NFS service not enabled, 3-18
No FC-AL or SCSI disk controllers!,
3-15
Non Maskable interrupt, 3-18
Parity disk is broken, 3-18, 3-19
Parity disk x% rebuilt, 3-19
POST error messages, 3-11
Power supply degraded!, 3-19
Replace NVRAM batteries!, 3-19
Reporting SNMP traps, 3-20
Setting time from remote host, 3-20
Setting up SNMP trap host, 3-20
STDBY/SERV, 3-3
Unsupported NVRAM size xMB, 3-16
x default route, 3-20
x route to y, 3-20
#
Maintenance mode message, 3-18
maximum current, for the filer, 2-2
memory
See also
DIMMS