Filter
Top Products
Installing a Filer System 2-19
0.
To connect an ASCII terminal to the filer, perform the following steps:
1. Ensure that the terminal settings match the filer’s, listed in Table 2-8.
Refer to the documentation for your terminal for further details.
+
2. Connect the cable’s socket end to the filer’s plug connector, labeled CONSOLE.
Use the provided DB-9–to–DB-9 serial cable.
Figure 2-13 shows the location of the CONSOLE port.
'
#,
If you are connecting an ASCII terminal from a remote site, be sure that you do not
have a local terminal connected to the filer’s CONSOLE port.
0 --
1
Line speed 9600 baud
Data bits per character 8
Parity None
Stop Bits 1
Flow Control None
Console port