Filter
Top Products
Connect low anchor connectors to vehicle lower
anchors.
- Position the lower anchor belt with the
belt adjuster slide button facing away
from the car seat. If the adjuster is not
in that position, turn the belt and adjuster
over. Check that lower anchor belt is flat,
not twisted.
- With hook-on connector opening facing down ,
position the opening of the connector over the
vehicle lower anchor. Push down and then
pull out on the connector to lock it onto the
vehicle anchor (fig. f). You should hear a click.
- Pull on connector to be sure it is locked onto
the anchor.
- Repeat for connector on opposite side.
Tighten lower anchor belt to secure the car seat.
-Press down in center of car seat to depress
the vehicle cushion and pull free end of lower
anchor belt to tighten belt (fig. g).
21
(fig. f)
2
3
1
(fig. g)
10
1
2
3
9
Check recline of car seat. Line inside level
indicator MUST be in green striped zone (fig. e).
If line is not in green striped zone, adjust recline
position or place tightly rolled up towel, blanket
or firm foam (pool noodle) under end of car seat
contacting vehicle seat back (fig. h).
If car seat can not be adjusted to locate
the line in the green striped zone:
1. Try a different seating position.
2. Do not use this car seat.
NOTE: Vehicle must be parked on horizontal
surface and child in car seat when
checking angle of car seat.
Check for secure installation. Gripping car seat at
top of armrest, pull car seat front to back and left
to right to check for secure installation (fig. i).
LATCH belt MUST stay tight.
- If LATCH belt does not stay tight or car seat
can not be securely installed, try a different
LATCH location or use the vehicle’s seat belt
to secure the car seat.
Recheck recline of car seat. Adjust if necessary
(see step 11).
22
(fig. i)
Towel or
Pool Noodle
(fig. h)
12
11
13