Filter
Top Products
After selecting a seating location,
if adjustable, adjust vehicle seat
back into most upright position.
Rotate car seat on lower base to
rear-facing position, see “Changing
Forward-Facing/Rear-Facing Use
Position” section.
Remove the lower anchor connectors
from their storage locations on back
of car seat pad (fig. a).
- Depress spring on hook-on
connector (fig. b) and remove
from LATCH connector storage
ring.
Lengthen lower anchor belt by
pressing down on belt adjuster
slide button on top of belt
adjuster and pulling belt to
extend the length of lower
anchor belt (fig. c).
19
(fig. c)
Lower
Anchor Belt
Belt
Adjuster
Pull
(fig. a)
Hook-on
Lower Anchor
Connector
3
2
4
5
(fig. b)
Belt Adjuster
Slide Button
Opening
Hook-on
Connector
LATCH Connector
Storage Ring
20
(fig. d)
Rear-facing
Belt Path
6
8
7
(fig. e)
Green
Striped Zone
Level
Indicator
Check that the lower anchor belt is through
the belt path openings marked “Belt Here
Rear-facing” (fig. d). If lower anchor belt is
not through the rear-facing belt path openings,
see “LATCH - Changing Belt Path Location”
section.
Place car seat rear-facing in the vehicle
seat location selected with rear-facing
belt path toward vehicle seat back and
centered between the vehicle lower
anchors (fig. d).
Recline car seat keeping the line inside
level indicator in the green striped zone
(fig. e). To change recline position, see
“Recline Position Adjustment” section.
NOTE: Level indicator is located on the
opposite side of car seat and not
on the side shown.