Filter
Top Products
48
2.2.3 Securing on the Corsaire XL and Captain XL models
First guide the
bungee cord supplied
through the lateral flaps
that are at the bottom
towards the front and
pull it very tight.
When viewed from the
inside of the transpor-
ter, the bungee cord
and flaps should be
positioned in front
of the vertical frame
tubes.
2.2.3.2 Lateral positioning
Thread the end of the strap as
shown in the above illustration
through the fastener in the baby
seat and gently pull the strap
tight.
Illustration A
Place the baby seat in the
trailer as shown in the above
picture.
2.2.3.1 Preliminary steps
Start with the strap that points
outwards at the front of the
baby seat.
Thread it down in front of the
telescopic tube.
Thread the strap through the flap
at the bottom – the bungee cord
is pulled through this as well. Now
once again, in front of the teles-
copic tube, pull it upwards again.
Fitted baby seat ready to use in the centre and side position:
Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again
beforehand.)
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the
other four straps tight. If you want an adjustment of greater incline, the procedure is the same but reversed.
Please note: Make sure you check all belt buckles are tight.
Please note:
Never transport your
children without the safety
belts being properly and
fully adjusted, otherwise
your child could be
seriously or even fatally injured
in the event of an accident!