Filter
Top Products
45
Insert the shoulder harness that
is on the appropriate side of the
baby seat through the lower or
upper slot of the baby seat,
depending on the size of the child.
Working towards the rear, insert
the shoulder harness through
the ring of the lap belt and the
corresponding slot on the other
side of the baby seat.
Connect the insert of the fastex
buckle with its unit on the
backrest of the trailer seat.
(The fastex buckle should be in
its lowest position.)
For centre-fitting, the right hand shoulder harness in the direction of travel is threaded through the
baby seat as described above, and the insert of the fastener is connected with the unit of the left hand
shoulder harness looking in direction of travel.
Now lay both the straps that are
at the top end of the baby seat
around the top crossbar inside
the trailer.
Thread the strap through as
illustrated…
…and pull the strap tight.
Fitted baby seat ready to use in the centre and side position:
Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again
beforehand.)
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the
other four straps tight. If you want an adjustment of greater incline, the procedure is the same but
reversed.
Please note: Make sure you check all belt buckles are tight.
Please note:
Never transport your
children without the safety
belts being properly and
fully adjusted, otherwise
your child could be
seriously or even fatally injured
in the event of an accident!
Illustration A