Filter
Top Products
11.0 SERVICE SECTION
To set the Service Parameters it will be necessary to enter the User Parameters
as before and then use a password code while entering the programming
parameter “PROG”.
11.1 CFW FACTORY PROGRAMMING AND CALIBRATIONS
• The parameter “PROG” allows access to the calibration section. To enter
this parameter press [Func] and then press [Tare/Ï] until "PROG" is
displayed.
• The Programming Parameter “PROG” has a number of sub-parameters that
allow the scale to be customised for the application. The “P1 rEF” sub-
parameter includes many functions that can affect the metrology of the
scale. These functions should not be reset to other values unless you
understand the affect it may have on the scale.
• Press [Zero/Enter] when “PROG” is displayed to show " PIn ", requesting for
the security password.
• Press the [Units], [Func] and [Print] keys in sequence to enter the
Programming/ Calibration menu. The display will show "P1 rEF". Press
[Zero/Enter] to set the functions of “P1 rEF”.
@Adam Equipment Company 2006
23